Hot Water Heater - Kuuma Aluminium 24 Litre with Side Mount Tabs 40610 
(Kuuma  was formerly branded Force 10 Marine)

This marine water heater creates hot water from either a fresh water cooled engine or from 240V power.
These marine hot water systems are designed for use in boats, and are also installed in many motor homes, RV's and transport trucks. 

Tested and certified to the latest Australian standard AS/NZS 60335.2.21-2002 - ESO Approval No. Q080349 and ignition protected.
All Kuuma water heaters are now supplied with a sacrificial anode. 
A direct replacement for most Seaward, & Atwood Marine Water heaters the Australian versions of Kuuma/Force 10's have improved pressure and temperature relief valves and improved elements with polymer end caps.

• Capacity: 6 Gallons (24 litres)
• Case Material: Aluminium
• Voltage: 230 Volt AC 1500 Watts
• Mounting Tabs Postion: Sides

Dimensions: See the Dimensional Drawing  PDF above for full detailed drawings.

• Width Overall: 394mm
• Width excluding tabs: 346mm
• Depth Overall: 482mm (includes fittings)
• Depth Excluding Fittings:  411mm
• Height: 346mm
• Dry Weight: 15kg

All Kuuma water heaters are now supplied with a sacrificial anode – this is the initial anode only and any subsequent anodes must be purchased separately.
Anodes should be checked at least every three (3) to four (4) months. Refer to the manual for advice on tank maintenance & care.

* Designed for engines that are freshwater cooled - they are not recommended for use with raw/salt water in the engine heat exchange circuit as this will shorten the life of your water heater.
These water heaters are commonly used on boat brands such as Azzurra, Beneteau, Campion, Chris craft, Crownline, Doral, Donzi, Hunt, Hunter, Leopard, Nordic tug, Mustang, Princecraft, and  Sabre Boats.