Rear Mount Kit for 401/402/500/501/502 Hydrive Steering Helm Pumps 

Use or Benefit:

This kit recesses the steering helm assembly back into the dash, so there is more room between the helmsman and the steering wheel.

The second picture above shows an example of a standard Hydrive helm where the wheel is a little too close to the helmsman -  this rear mount kit recesses the helm back into the dash to give more room.

When installing a new Hydrive Admiral or Commander steering kit it brings the steering wheel a little closer to the helmsman's stomach so it is a good idea to use this kit which gives more room between the wheel and the helmsman/woman.

The REAR-MOUNT KIT fits any model 401, 402 or 500/501/502 helm unit and is adjustable from low-profile to full protrusion for maximum flexibility in helm placement. Simply trim the spacers and studs to adjust the amount of protrusion into the helm position. The front dash or console ring is fully O-ring sealed against the pump body to prevent water ingress to the rear of the console.
Easy to fit - it can be retro fitted but is easier at the time of steering kit installation.

(990146)

What's in the Box?

  • 2 x circular flange rings with pre-drilled bolt holes
  • 4 long threaded bolts
  • 4 x Spacer tubes
  • Hardware bolts, nuts,washers etc
  • Gaskets
  • Instructions
  • Drilling Template

 

SKU 990146
Model # REAR-MOUNT
Brand Hydrive
Shipping Weight 4.0000kg
Shipping Width 0.200m
Shipping Height 0.200m
Shipping Length 0.270m
Unit Of Measure Kit

Hydrive 2 Year Warranty