Electronic Control Unit Suits DC BD35/BD50 Post 1998
Suits DC BD35 and BD50 Compressors
Isotherm Electronic DC Control Unit Module - 381840 - SEG00002DA
Suits all DC Danfoss BD35 and BD50 Compressors Post 1998 (DC Only not AC)
101N0212 (also replaces the old 101N0210)
12-24 volt Electronic module for all DC only Danfoss BD35 and BD50 compressors, used on Isotherm® refrigeration since 1998.
Connects to the compressor with three pins.This is the latest version of the DC module for BD35 and BD50 compressors.
It is a direct replacement for Part number 101N0210, SECOP part number #101N0212, and Frigoboat part E50896.
Replacement 12/24V electronic module for Danfoss and SECOP BD35 and BD50 Compressors.
Case size: 2 5/8" x 4 1/8" x 1 3/4"
Practical Tech Tip:
To test this module:
- Put a jumper between the T (Thermostat) and C (Compressor) terminals.
- The compressor should start and run at low speed.
- If the compressor doesn't start, you may need to replace this module.
Can easily be shipped Australia wide.
|Unit Of Measure||Each|